Cisco 800 Series 디자인 매뉴얼 - 페이지 37

{카테고리_이름} Cisco 800 Series에 대한 디자인 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 800 Series 50 페이지. Fast step software design guide
Cisco 800 Series에 대해서도 마찬가지입니다: 릴리스 정보 (36 페이지), 빠른 시작 매뉴얼 (13 페이지), 빠른 시작 매뉴얼 (17 페이지), 구성 (32 페이지)

페이지 인쇄

Chapter 4

Custom Software Installation

Belle Systems Provisioning

The Belle System provisioning system allows a large number of routers to be installed by the users and

managed by Belle Systems software from the central site, as follows:

For this entire process to be executed from a CD-ROM that includes the Cisco 800 Fast Step software,

configuration, and Web pages requires that you do the following:

•

Cisco does not ask any license fees for making copies of Cisco 800 Fast Step, provided the standard

Cisco Systems licensing agreements are abided by.

Enabling Belle Systems Support

Belle System support loads the configuration from a remote server. The flag syntax is as follows:

[Belle Systems]

SetBelleSystemSupport=

If the flag value is set to 0 or blank, Belle Systems support is disabled.

If the flag value is set to 1, Belle Systems support is enabled.

OL-10373-02

Setup configures the PC as a DHCP client, the router as a DHCP server with PAT, and uses IPCP

to find the WAN address. This enables the router to connect to the registration server but nowhere

else.

Setup completes the configuration process and runs an installed Web browser that points to a local

HTML page or the Belle System remote registration page.

The users enter their Personal Identification Number (PIN) code, personal information, and, if the

router supports basic telephone service (POTS), the phone numbers of the attached telephone or

fax.

The registration server validates the PIN code and personal information, checks the Cisco IOS

software version (and, if necessary, downloads a new version), and the router configuration.

The router is rebooted. Changing the router configuration might change the dynamic host

configuration protocol (DHCP) pool addresses of the router, so the PC also must be rebooted to get

new IP addresses from the router. The final page of the registration server information tells the user

to reboot the PC.

Setup waits for a PC reboot, and, when it is successful, runs the Web browser, pointing to a local

HTML file placed in the Third Party Software directory or a URL that points to the registration

completion page. The remote page performs some background processing and logs the registration

information into the Belle Systems provisioning system.

Copy the directory structure of the Cisco 800 Fast Step CD to the hard drive where you are staging

the CD-ROM image.

Replace the autoload.CFG file in the disk1 directory with your customized version that uses the

same filename.

Place the local HTML pages into the Third Party Software directory. The Cisco 800 Fast Step

installation program automatically copies the contents of the source directory to the Third Party

Software directory on the hard disk, below the installation directory, normally

c:\program files\cisco systems\Fast Step ISDN\Third Party Software.

Belle Systems Provisioning

Cisco 800 Fast Step Software Design Guide

4-5