Cisco AIR-AP1010 - 1000 Series Lightweight Access Point 빠른 시작 매뉴얼 - 페이지 25
{카테고리_이름} Cisco AIR-AP1010 - 1000 Series Lightweight Access Point에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AIR-AP1010 - 1000 Series Lightweight Access Point 36 페이지. Aironet 1000 series ieee 802.11a/b/g lightweight access points with internal antennas
페이지 인쇄
Installation and Configuration
Be sure the cables are routed away from the AP antennas.
Note
Note
When the AP is powered up and is associated with a Cisco Wireless LAN Controller (Green/Power and
Yellow/802.11b/g and/or Yellow or Amber/802.11a LEDs lit), the AP begins broadcasting its beacon
signal(s). When this happens, complete the installation as quickly as possible to remove yourself from
within 8 inches (20 cm) of the AP to comply with FCC RF radiation exposure guidelines.
You have installed the AP. Repeat "
"Returning MAC Information
Returning MAC Information
When you have completed the installations as outlined in
addresses and their locations on the maps or floor plans to the network planner or manager. The Network
operators will use the MAC address and location information to create maps for precise wireless
Operating System management.
Also return any unused mounting kit hardware and external power supplies to the network planner or
manager for use in future deployments.
Please remind the Network Planner or Manager that now is a good time to register the APs.
Note
7817146-01
Preparing Mounting
".
AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal
Locations"
for each AP location, and then continue with
"Mounting the Access
Returning MAC Information
Points", return the MAC
13