Cisco AIR-AP1142N-E-K9 시작하기 매뉴얼 - 페이지 11

{카테고리_이름} Cisco AIR-AP1142N-E-K9에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AIR-AP1142N-E-K9 37 페이지. Autonomous access point

Configure the settings using the following sections as a guide.

Step 5

• Host Name—The host name (or system name) is a name for the access point that identifies

it on your network. The system name appears in the titles of the management system

pages.

• Configuration Server Protocol—This setting specifies how the access point obtains an IP

address.

DHCP—IP address is automatically assigned by the network DHCP server.

–

Static IP—The access point uses a static IP address that you enter in the IP address

–

field.

• IP Address—This setting assigns or changes the access point IP address. If DHCP is

enabled, the access point obtains its IP address from your network DHCP server. You can

assign a static IP address in this field.

• IP Subnet Mask—The IP subnet mask identifies the subnet on which the access point

resides. This subnet is provided by your network administrator. If DHCP is enabled, leave

this field blank.