Cisco AIR-AP1210 - Aironet 1200 - Wireless Access Point External 사용자 설명서 - 페이지 22
{카테고리_이름} Cisco AIR-AP1210 - Aironet 1200 - Wireless Access Point External에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AIR-AP1210 - Aironet 1200 - Wireless Access Point External 36 페이지. Aironet 1100/1200 series
Cisco AIR-AP1210 - Aironet 1200 - Wireless Access Point External에 대해서도 마찬가지입니다: 주문 매뉴얼 (6 페이지)
페이지 인쇄
3. Place the card in an anti-static bag.
Installing the 802.11g Radio Card
Follow these steps to install the 802.11g radio card:
1. Carefully remove the radio card from its anti-static bag.
2. Grasp the card by its edges, being careful not to touch components on
the card or the gold connector pins.
3. Carefully connect the black wire's antenna connector to the radio card
antenna connector marked J2 (the connector on the outside of the card).
4. Carefully connect the white wire's antenna connector to the radio card
antenna connector marked J1 (the connector on the inside of the card)
connector).
5. Insert the radio card into the access point's mini-PCI connector by
following these steps:
a. Tilt the card at approximately 20 to 30 degrees so that its gold pins
are aligned with the mini-PCI connector.
b. Insert the card into the mini-PCI connector and gently push the card
until it is firmly seated as shown in the following illustration.
22