Cisco AIR-AP1800I-B-K9 시작하기 매뉴얼 - 페이지 9

{카테고리_이름} Cisco AIR-AP1800I-B-K9에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AIR-AP1800I-B-K9 43 페이지.

Preparing the AP for Installation

Before you mount and deploy your access point, we recommend that you perform a site survey (or use

the site planning tool) to determine the best location to install your access point.

You should have the following information about your wireless network available:

• Access point locations.

• Access point mounting options: vertically oriented, on a wall or a desk.

• Powered by 802.3af or 802.3at, through PoE from a network device or a PoE power injector or

hub (usually located in a wiring closet).

Access points mounted in a building's environmental airspace must be powered using PoE

Note

to comply with safety regulations.

Cisco recommends that you make a site map showing access point locations so that you can record the

device MAC addresses from each location and return them to the person who is planning or managing

your wireless network.

Installation Overview

During installation, gently adjust the module and radio unit such that the internal connectors are

aligned and centered. Now, gently snap them into place.

To assemble the module and radio unit, do not use excessive force. This will prevent

Caution

irreversible physical connector damage.

Installing the access point involves these operations:

Performing a Pre-Installation Configuration, page 10

Step 1

Mounting and Powering the Access Point, page 13

Step 2

Configuring and Deploying the Access Point, page 16

Step 3

(optional)