Cisco AIR-AP1800I-Z-K9 시작하기 매뉴얼 - 페이지 13

{카테고리_이름} Cisco AIR-AP1800I-Z-K9에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AIR-AP1800I-Z-K9 43 페이지.

Mounting and Powering the Access Point

The Cisco Aironet 1800i series access points can be mounted, in a vertical orientation, on a wall or

desk, to a height of 3 feet. The mounting is done using the wall-mount bracket AIR-AP-BRACKET-NS.

To mount the AP on a wall or desk:

Identify the location for mounting the AP.

Step 1

Step 2

Use the wall-mount bracket AIR-AP-BRACKET-NS, as a template to mark the two screw-hole

locations for fastening the bracket to the wall or desk.

At the marked locations, drill a hole into the wall or desk.

Step 3

Step 4

Fasten the AIR-AP-BRACKET-NS to the wall using two 18mm screws.

Hold the back of the AP against the wall, above the bracket, and then slide the AP down onto

Step 5

the bracket, till it clicks into place. The hooks on the bracket will click into the recesses on

the back of the AP.

Proceed with connecting the data and power cables.

Step 6

The AP can be powered using only the following power sources and devices:

• AC power, using the AC-USB adapter AIR-MOD-USB, supplying 5V DC, 1.5A power.

• PoE, 802.3af Class 0 power or greater, from:

a network device or power injector.

–

Cisco power injectors AIR-PWRINJ5 (for 802.3af) or AIR-PWRINJ6 (for 802.3at).

–

The PoE and USB ports are located on the base of the AP. When both AC power (through USB) and

PoE power is available, the PoE power takes precedence.

Cisco recommends that you use only the Cisco supplied AC-USB adapter AIR-MOD-USB,

Note

(7.5 W, supplying 5V DC, 1.5A power), for powering the AP through the USB port. Other

power supply devices which do not meet the specifications of the Cisco supplied device, can

cause silent reboots or crashes.