Cisco AIR-CAP3702I-E-K9 시작하기 매뉴얼 - 페이지 13

{카테고리_이름} Cisco AIR-CAP3702I-E-K9에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AIR-CAP3702I-E-K9 45 페이지.

페이지 인쇄
Cisco AIR-CAP3702I-E-K9 시작하기 매뉴얼

Pre-Installation Configuration Setup

The pre-installation configuration setup is shown in
Figure 4
Pre-Installation Configuration Setup
To perform pre-installation configuration, perform the following steps:
Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use
Step 1
the CLI, web-browser interface, or Cisco WCS procedures as described in the appropriate
Cisco wireless LAN controller guide.
a. Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller
Management and AP-Manager Interface.
b. Configure the switch to which your access point is to attach. See the Cisco Wireless LAN
Controller Configuration Guide, Release x.x for additional information.
c. Set the Cisco wireless LAN controller as the master so that new access points always join with
it.
d. Make sure DHCP is enabled on the network. The access point must receive its IP address
through DHCP.
Figure
Controller
Layer 3
devices
Cisco Aironet
access points
4.
13