Cisco AIR-LAP1310G 설치 지침 - 페이지 21

{카테고리_이름} Cisco AIR-LAP1310G에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AIR-LAP1310G 40 페이지. Cisco aironet 1300 series lightweight outdoor access point

페이지 인쇄

1. Mounting the Access Point

Connect the cables to the access point (or lowest grounding block on the tower). The cables should slope

Step 6

downward so that moisture runs away from the connectors during rainstorms. If necessary, form drip

loops near the connectors.

Cut the cables to length, install F-connectors on the ends, and connect them to the grounding block.

Step 7

Step 8

Weather seal all coaxial connectors by wrapping them with the sealant tape provided with the installation

kit. For more information, see the

Mast Mount

Mounting the access point on a tall mast makes antenna positioning difficult because you cannot view

the access point LEDs or adjust the antenna vertically. If possible, use a mast short enough so that you

can reach the access point from a step ladder or other support. Otherwise, you may need to take down

the mast to adjust the antenna position.

Mounting the access point on a mast includes the following subtasks:

This warning applies to outdoor installations.

Warning

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Statement 1030

Preparing the Mast

To prepare the mast, follow these steps:

Choose a mounting location for the mast. For more information, see the

Step 1

Location" section on page

Find a solid mounting position on the building for the mast mounting bracket, such as a stud or main

Step 2

building member on a roof or external wall. Use a stud finder, if necessary, to find wooden structural

members.

Find the mast-mounting hardware and guy wire.

Step 3

Find and install the guy line mounting points. A minimum of three, preferably four, guy lines should

Step 4

hold the mast in position.

Measure the length of the guy lines by attaching the lines to the mast at their mounting point and

Step 5

unspooling them to the attachment points.

Raise the mast to its vertical position and temporarily secure all guy lines to their mounting points.

Step 6

Ensure that the mast is vertical using a level on two sides (90 degrees apart) of the pole. Adjust guy lines

Step 7

as necessary and note their attachment points.

78-17634-01

Preparing the mast

Mounting the access point

Routing mast cables

Raising the mast and connecting cables

Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions

"Applying Coax Seal Tape" section on page

Mounting the Access Point

24.

"Choosing a Mounting