Cisco AIR-LAP1310G 설치 지침 - 페이지 26

{카테고리_이름} Cisco AIR-LAP1310G에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AIR-LAP1310G 40 페이지. Cisco aironet 1300 series lightweight outdoor access point

페이지 인쇄

1. Mounting the Access Point

Mounting the Access Point

Visually inspect the seal to make sure the entire connector area is completely covered. If you find gaps,

Step 5

apply additional Coax-Seal over the existing material and then mold it to shape.

Step 6

Repeat this procedure for each coaxial connection on the access point and grounding blocks.

Assembling the Mounting Hardware

The access point mounting hardware can accommodate tower, mast, or rooftop installations. The

mounting hardware comprises the following key parts:

•

Assembling the Rooftop Mount

The rooftop mount or wall mounting bracket (see

horizontal or vertical surface, such as a building roof or wall. You must assemble the rooftop mount

before you can use it. Skip this section if you are not using the rooftop mount.

To assemble the mount, follow the instructions below:

Place a washer on the long flanged hex bolt.

Step 1

Place the end of the mast pipe with the bolt holes into the base plate (see

Step 2

Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions

Housing brackets

Mounting bracket

Rooftop mount or wall mounting bracket

Figure

9) is used to mount your access point to a flat

Figure

9).

78-17634-01