Cisco AIR-LAP1310G 설치 지침 - 페이지 36

{카테고리_이름} Cisco AIR-LAP1310G에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AIR-LAP1310G 40 페이지. Cisco aironet 1300 series lightweight outdoor access point

페이지 인쇄

1. Mounting the Access Point

Using a DC Power Source

Only a qualified electrician or service person should make and install the power cable with in-line fuse

Caution

supplying DC-power to the power injector.

To prevent damage to the access point or power injector, connect all coax cables from the power injector

Caution

to the access point and connect the power jack to the power injector before applying power.

The power plug has a screw-on cap to secure the power cable to the power injector. The mating power

plug is a Switchcraft 760K (see

Figure 15

Inline Power Fuse

When you mount the access point in a vehicle, an inline power fuse must be used in the positive (+)

power line going to the power injector.

The inline power fuse must be listed and certified to the appropriate safety standards for the country

Note

where the access point is installed.

Table 2

Vehicle Power Source

+12 VDC

+24 VDC

+37.5 VDC

+40 VDC

Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions

Figure

Power Plug

provides the inline power fuse requirements:

Inline Power Fuse Requirement

15).

Inline Fuse (Slow-blow)

1.7 A

600 mA

360 mA

335 mA

78-17634-01