Cisco AIR-MP20B 사용자 설명서 - 페이지 13

{카테고리_이름} Cisco AIR-MP20B에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AIR-MP20B 36 페이지. Aironet 1100/1200 series

9. Carefully position the antenna wires so that the metal connectors do not

touch each other.

10. Verify the following:

a. The card is properly secured with both retaining clips engaged.

b. The antenna board is properly secured.

c. The antenna connectors are not touching.

Caution

Do not allow the antenna connectors to touch while power is

applied. If they are touching, carefully rotate them in opposite

directions until they are separated.

Replacing the Back Cover

Follow these steps to replace the back cover:

1. While holding the back cover near the connector end of the access point,

carefully place the latches on the antenna end into the detents on the end

of the front cover.

2. Release the back cover and with one finger gently push the connector

end of the back cover towards the antenna end. The back cover drops into

place and slides forward until it is fully seated.