Cisco Aironet 1250 Series 매뉴얼 - 페이지 24

{카테고리_이름} Cisco Aironet 1250 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1250 Series 37 페이지. Aironet 1250 series
Cisco Aironet 1250 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (40 페이지), 데이터시트 (14 페이지), 하드웨어 설치 매뉴얼 (10 페이지)

페이지 인쇄

1. Configuring the Access Point

– A switch with inline power.

– The Ethernet connector on the 1250 series power injector labeled To

AP.

Step 3

When using the power injector, connect a Category 5E (or higher)

Ethernet cable from your your inline power switch to the power

injector connector labeled To Switch.

Step 4

When using the power injector, connect an AC power cord to the

power injector and the AC wall socket.

Connecting to an Ethernet Network with Local Power

Note

If your access point is connected to in-line power, do not connect the

DC power module to the access point. Using two power sources on

the access point might cause the access point to shut down to protect

internal components and might cause the switch to shut down the

port to which the access point is connected. If your access point

shuts down, you must remove all power and reconnect only a single

power source.

78-17831-01