DigitaLinx DL-FHD2 소유자 매뉴얼 - 페이지 10

{카테고리_이름} DigitaLinx DL-FHD2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigitaLinx DL-FHD2 18 페이지.

DL-FHD2 Owners Manual

Connecting Control

Passing IR Signals

The DL-FHD2 is capable of passing IR signals between 33 and 55 KHz. To prevent damage to any of the elec-

tronics, the extenders should be powered off while inserting or removing any IR components. Inserting an IR

transmitter into the IR IN port may damage the IR circuit for that extender.

IR OUT: The IR transmitter (IR emitter) must be plugged into the IR OUT port.

IR IN: The IR receiver (IR eye) must be plugged into the IR IN port.

To connect to a 3rd party IR system such as a control system, the Digitalinx IR-AC IR coupling cable (sold sep-

arately) is required. Connect the TS connector of the IR-AC coupling cable to the IR output port of the control

system and connect the TRS connector of the IR-AC cable to the IR IN to either transmitter or receiver of the

DL-FHD2�

RS232 Control Wiring

Connect the controller or device RX signal to TX port of the DL-FHD2 transmitter / receiver. Then connect the

controller or device TX signal to the RX port on the DL-FHD2 transmitter / receiver.

Apply Power

Plug the power supply into the power input port on the rear of DL-FHD2 receiver and transmitter. For proper

operation both the transmitter and receiver must be powered simultaneously.

DL-FHD2

Controller or

(TX/RX)

Device

RXD

TXD

GND