DigitaLinx DL-HD2100 소유자 매뉴얼 - 페이지 9

{카테고리_이름} DigitaLinx DL-HD2100에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigitaLinx DL-HD2100 17 페이지. Hdbaset extender set
DigitaLinx DL-HD2100에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (8 페이지), 빠른 설치 매뉴얼 (8 페이지)

페이지 인쇄

Connecting IR Control

The DL-HD2100 is capable of transmitting bi-directional IR signals through the HDBaseT circuit. The DL-HD2100

comes with 2 IR receivers (eye) and 2 IR emitters (flashers) so you can control devices from either end of the

extender circuit.

Passing IR Signals:

The DL-

any of the electronics, the extenders should be powered off while inserting or removing any IR

components. Inserting an IR transmitter into the IR IN port may damage the IR circuit for that

extender.

Source Device Control using IR

Attach the IR emitter to the IR receiver of the source device, insert the TS 3.5 mm plug of the emitter to the IR

OUT port of the DL-HD2100 transmitter. Insert the TS 3.5 mm plug of the IR receiver (eye) to the IR IN port of the

DL-HD2100 receiver. Point the source device IR remote at the display location where the IR receiver is located,

IR signals will now travel through HDBaseT to the DL-UHDRC70 transmitter side where the IR emitter is attached

to the source device.

Remote Display using IR

Attach the IR emitter to the IR receiver of the display device, insert the TS 3.5 mm plug of the emitter to the IR

OUT port of the DL-HD2100 receiver. Insert the TS 3.5 mm plug of the IR receiver (eye) to the IR IN port of the

DL-HD2100 transmitter. Point the source device IR remote at the source device location where the IR receiver

is located, IR signals will now travel through HDBaseT to the DL-HD2100 receiver side where the IR emitter is

attached to the display device.

Source / Display Control from Control System

To pass 3rd party IR system signals through the DL-HD2100, such as a control system, connect the TS connec-

tor of the IR-AC coupling cable (provided) to the IR output port of the control system and connect the TRS

connector of the IR-AC cable to the IR IN to either transmitter or receiver of the DL-HD2100.

HD2100

is capable of passing IR signals between 33 and 55 KHz. To prevent damage to

DL-HD2100 Owners Manual