DigitaLinx DL-HD70 빠른 설치 매뉴얼 - 페이지 3
{카테고리_이름} DigitaLinx DL-HD70에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigitaLinx DL-HD70 8 페이지.
DigitaLinx DL-HD70에 대해서도 마찬가지입니다: 설치 매뉴얼 (2 페이지)
페이지 인쇄
1
1.
DC 18V
• Locking power port, connect DC18V power adapter (either power port can power enti re set)
2.
Twisted Pair
• RJ45 HDBaseT connecti on. Connect Cat6 cable to transmitt er
3.
IR In
• 3.5mm IR input port for connecti on to IR receiver or IR system
4.
IR Out
• 3.5mm IR output port for connecti on to IR emitt er
5.
RS232
• 3 pin Phoenix connector port for connecti ng / passing RS232 control
6.
HDMI In
• HDMI input port for connecti ons to video sources
7.
Mode - Normal- for normal operati on. Update- for fi rmware update process
• The mode switch is used when updati ng fi rmware in the extender. A separate document will
provide usage instructi ons once a new fi rmware update is available.
Front Panel Diagnosti c LEDs:
The DL-HD70 provides four blue LEDs to indicate the current operati ng status and to assist
troubleshooti ng an installati on.
Power: Solid, the DL-HD70 extender is receiving power from the power supply or from the
remote extender via Category 6 cabling.
Status: Flashes once per second, the HDBaseT processor is running.
Link: Solid, the two DL-HD70 extenders are communicati ng via Category 6 cabling.
HDCP: Solid, HDCP signal is present in the HDMI stream. Flashes quickly, no HDCP signal is
present in the HDMI stream.
Transmitt er View
2
3
4
5
6
7