Cisco Aironet 1400 Series 매뉴얼 - 페이지 28

{카테고리_이름} Cisco Aironet 1400 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1400 Series 35 페이지. Wireless bridge
Cisco Aironet 1400 Series에 대해서도 마찬가지입니다: 사양 시트 (16 페이지)

페이지 인쇄

Configuration Server Protocol—Click the button that matches your

network's method of IP address assignment:

•

DHCP—IP addresses are automatically assigned by your network's

DHCP server. This is the default setting unless a DHCP server cannot be

found.

•

Static IP—IP addresses are assigned manually.

IP Address—Displays the current IP address. The default IP address is

10.0.0.1. Use this setting to assign or change the bridge's IP address. Use the

IP setup utility (IPSU) to determine the IP address if it was assigned by a

DHCP server. See Chapter 4 of the Cisco Aironet 1400 Series Wireless Bridge

Hardware Installation Guide.

IP Subnet Mask—Enter the IP subnet mask. The default IP subnet mask is

255.255.255.224. The subnet mask determines the subnet to which the

bridge's IP address belongs. If DHCP is not enabled for your network, the IP

and subnet address you enter is the bridge's IP and subnet address. If DHCP

is enabled, these two fields provide the IP and subnet mask address only if no

server responds to the bridge's DHCP request.

Default Gateway—Enter the default gateway IP address. The default

gateway IP address is 0.0.0.0. The default gateway is the node on your

network that serves as an entrance to another network.

SNMP Community—Enter the SNMP community the bridge will use for

network management and assign the attributes for the community: read-only

or read-write.