DigitaLinx DL-HD70LSIR 빠른 설치 매뉴얼 - 페이지 4
{카테고리_이름} DigitaLinx DL-HD70LSIR에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigitaLinx DL-HD70LSIR 8 페이지.
DigitaLinx DL-HD70LSIR에 대해서도 마찬가지입니다: 소유자 매뉴얼 (13 페이지)
페이지 인쇄
DL-HD70LSIR Quick Guide
1. Verify all components included with the extender set are present before installati on.
2. If the extenders are going to be permanently mounted to a surface, att ach the included mounti ng
brackets with the supplied screws.
3. Turn off power and disconnect the audio/video equipment by following the manufacturer's
instructi ons.
4. Connect Category 6 or greater twisted pair cable with RJ45 connectors between the DL-HD70LSIR
transmitt er and the receiver. TIA/EIA-568B straight-through wiring connecti ons must be used with all
HDBaseT extenders.
5. Connect an HDMI cable and any desired IR control accessories between the display and the
DL-HD70LSIR receiver.
6. Connect an HDMI cable and any desired IR control accessories between the source and the
DL-HD70LSIR transmitt er.
7. Connect the included power supply to the DL-HD70LSIR transmitt er or receiver and lock the power
supply to the power connector by twisti ng the locking collar clockwise.
8. Power on att ached audio/video devices.
Passing IR Signals:
The DL-HD70LSIR is capable of passing IR signals between 33 and 50 KHz. To prevent
damage to any of the electronics, the extenders should be powered off while inserti ng
or removing any IR components. Inserti ng an IR transmitt er into the IR IN port may
damage the IR circuit for that extender.
IR OUT: The IR transmitt er (IR emitt er) must be plugged into the IR OUT port.
IR IN: The IR receiver (IR eye) must be plugged into the IR IN port.
To pass 3rd party IR system signals through the DL-HD70LSIR, such as a control system,
connect the TS connector of the IR-AC coupling cable (provided) to the IR output port
of the control system and connect the TRS connector of the IR-AC cable to the IR IN to
either transmitt er or receiver of the DL-HD70LSIR
4
Connecti vity Instructi ons