Cisco Aironet 1520 Series 시작하기 매뉴얼 - 페이지 27
{카테고리_이름} Cisco Aironet 1520 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1520 Series 37 페이지. Outdoor mesh access point
Cisco Aironet 1520 Series에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (50 페이지), 매뉴얼 (27 페이지)
페이지 인쇄
To configure DHCP Option 43 for Cisco 1000 and 1500 (1505 and 1510) series lightweight access
points in the embedded Cisco IOS DHCP server, follow these steps:
Enter configuration mode at the Cisco IOS command line interface.
Step 1
Create the DHCP pool, including the necessary parameters such as default router and name
Step 2
server as shown in the following example:
ip dhcp pool pool name
network IP Network Netmask
default-router Default router
dns-server DNS Server
Where:
pool name is the name of the DHCP pool, such as AP1000.
IP Network is the network IP address where the controller resides, such as
10.0.15.1
Netmask is the subnet mask, such as 255.255.255.0
Default router is the IP address of the default router, such as 10.0.0.1
DNS Server is the IP address of the DNS server, such as 10.0.10.2
Step 3
Add the Option 60 line using the following syntax:
option 60 ascii "VCI string"
For the VCI string, use the value from Table 3. The quotation marks must be included.
Add the Option 43 line using the following syntax:
Step 4
option 43 ascii "Comma Separated IP Address List"
For example, if you are configuring Option 43 for Cisco 1000 or 1500 series access points
using the controller IP addresses 10.126.126.2 and 10.127.127.2, add the following line to
the DHCP pool in the Cisco IOS CLI. Be sure to include the quotation marks:
option 43 ascii "10.126.126.2,10.127.127.2"
The quotation marks must be included.
27