DigitaLinx DL-HDE100 빠른 설치 매뉴얼 - 페이지 6
{카테고리_이름} DigitaLinx DL-HDE100에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigitaLinx DL-HDE100 8 페이지. Extender set transmits hdmi, bidirectional ir, rs232 and
ethernet up to 100 meters away using a single category 6 twisted pair cable.
DigitaLinx DL-HDE100에 대해서도 마찬가지입니다: 설치 매뉴얼 (4 페이지), 소유자 매뉴얼 (16 페이지)
페이지 인쇄
HDBaseT Cabling
To ensure proper performance of the DL-
shielded Category 6 F/UTP cabling at a minimum. Category 5e F/UTP may perform well but
may not support power over HDBaseT reliably.
For optimized HDBaseT performance use the following Liberty Wire and Cable branded
cabling;
Category 6 plenum; 24-4P-P-L6SH
Category 6A plenum; 24-4P-P-L6ASH
Category 6 NON-plenum; 24-4P-L6SH
Category 6A NON -plenum; 24-4P-L6ASH
1
8
Cabling Requirements
When using shielded category cabling ALWAYS...
....use shielded connectors
....properly ground the category cable
TIA/EIA-568B
P n 1
Or n e/Wh te
P n 2
Or n e
P n 3
Green/Wh te
P n 4
Blue
P n 5
Blue/Wh te
P n 6
Green
P n 7
Brown/Wh te
P n 8
Brown
, it is recommended that you use solid core,
HDE100
Twisted Pair Wiring
Use TIA/EIA-568B wiring for Category 6
connection between send and receive
units.
RS232 Wiring
Connect the controller or device RX signal to
TX on the DL-
HDE100
controller or device TX signal to Rx on the
DL-HDE100 extender.
extender. Connect the