Cisco Aironet 1570 Series 하드웨어 설치 매뉴얼 - 페이지 9

{카테고리_이름} Cisco Aironet 1570 Series에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1570 Series 10 페이지. Outdoor access point
Cisco Aironet 1570 Series에 대해서도 마찬가지입니다: 주문 매뉴얼 (17 페이지)

페이지 인쇄

Chapter 2

Preparing for Installation

This equipment must be externally grounded using a customer-supplied ground wire before

Warning

power is applied. Contact the appropriate electrical inspection authority or an electrician if you

are uncertain that suitable grounding is available. Statement 366

Warning

Do not work on the system or connect or disconnect cables during periods of lightning activity.

Statement 1001

Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV)

Warning

requirements in IEC 60950 based safety standards. Statement 1033

To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord. Statement

Warning

1023

Caution

Power injectors must be used indoors only. Do not place a power injector in an unprotected outdoor

environment because water could get into the power injector and cause a short circuit and possible fire.

Caution

When the access point is installed outdoors or in a wet or damp location, the AC branch circuit that is

powering the access point should be provided with ground fault protection (GFCI), as required by Article

210 of the National Electrical Code (NEC).

Translated Safety Warnings

The document containing the Translated Safety Warnings for Cisco Aironet 1570 Series Outdoor Access

Points is provided on the following page on Cisco.com:

http://www.cisco.com/c/en/us/products/collateral/wireless/bulletin-c25-735595.html

OL-32138-01

Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide

Translated Safety Warnings

2-9