Cisco Aironet 1572EAC 배포 매뉴얼 - 페이지 32

{카테고리_이름} Cisco Aironet 1572EAC에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1572EAC 40 페이지. Aironet 1570 series

• There must be a preferred parent set for each daisy-chained mesh hop. The Master MAP should have a preferred parent.

• Daisy-chaining must be enabled on the AP, either via WLC GUI, WLC CLI, or AP CLI.

• Directional antennas should be used when creating a daisy-chain, which guides the mesh tree formation to the customer needs.

Enabling Daisy-Chaining using the WLC GUI

To enable Daisy-Chaining from the WLC GUI, go to Wireless > Access Point > (AP_NAME) > Mesh, and then check the

Daisy-Chaining check box. If the AP is used in a serial-backhaul solution, a Preferred Parent must be selected.

Enabling Daisy-Chaining using the WLC CLI

To enable Daisy-Chaining from the WLC CLI, issue the command:

(Cisco Controller) >config ap daisy-chaining [enable/disable] <ap_name>

The daisy chaining feature must be enabled on a per access point basis:

(Cisco Controller) >show ap config general <ap_name>

Then scroll down the Daisy Chaining entry

Daisy Chaining .................................. Disabled

Enabling Daisy-Chaining using the AP CLI

To enable Daisy-Chaining from the AP CLI, issue the command:

AP#capwap ap daisy-chaining <enable/disable>

Setting a Preferred Parent for each Serial-Backhaul AP

To set up a preferred parent for each serial-backhaul AP, issue the command:

(Cisco Controller) >config mesh parent preferred <ap_name> <PARENT_MAC_ADDRESS>

An access point's preferred parent can be seen by issuing: