DigitaLinx DL-S41 설치 매뉴얼 - 페이지 3
{카테고리_이름} DigitaLinx DL-S41에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigitaLinx DL-S41 8 페이지.
페이지 인쇄1.
Verify all components included with the switcher are present
before installation.
2.
If the switcher will be permanently mounted to a surface, attach
the included mounting brackets with the supplied screws.
3.
If the switcher will be sitting on a shelf, attach the included
rubber feet to the bottom of the unit.
4.
Turn off power and disconnect the audio/video equipment by
following the manufacturer's instructions.
5.
If the switcher needs to use preset a preset EDID instead of the
EDID of the connected display, set the EDID switches according to
the table below.
6.
Connect an HDMI cable between the sources and the HDMI
Input ports.
7.
Connect an HDMI cable between the display and the HDMI
Output port.
8.
Connect an analog audio cable with 3.5 mm stereo audio plug
to the Audio Output port.
9.
If the switcher will be controlled via IR, plug in the supplied IR
receiver to the IR In port.
10. If the switcher will be controlled via RS232, plug in the supplied
RS232 cable to the RS232 port.
11.
Connect the included power supply to the switcher.
12. Power on attached audio/video devices.
EDID Settings:
Up, Up, Up, Up
Up, Up, Up, Dn
Up, Up, Dn, Up
Up, Up, Dn, Dn
Up, Dn, Up, Up
Up, Dn, Up, Dn
Instructions
EDID Pass-through (default)
1080p 3D, 2 channel audio
1080p 3D, 6 channel audio (Dolby and DTS)
1080p, 2 channel audio
1080p, 6 channel audio (Dolby and DTS)
UHD at 30 Hz (3840x2160)