Cisco Aironet 1815T 시작하기 매뉴얼 - 페이지 12

{카테고리_이름} Cisco Aironet 1815T에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1815T 30 페이지. Officeextend access points

Table 1

LED Status Indications (continued)

Message Type

Cisco AP OS errors

Checking the Ethernet Port LEDs

Each Ethernet port has two LEDs for showing Link (Green) and Activity (Amber) statuses. They are

integrated on the RJ45 connector. For a description of the statuses they indicate, see the following

table.

Link (Green) LED State

Activity (Amber) LED State

Using the Mode Button

Using the Mode button you can:

• Reset the AP to it's default factory-shipped configuration.

• Clear the AP's internal storage, including all configuration files and the regulatory domain

configuration.

The Mode button is located on the back of the AP. You need to remove the back cover of the AP to

access the mode button.

To use the mode button, press, and keep pressed, the mode button on the access point during the AP's

boot cycle. Wait until the AP's status LED changes to Amber. During this, the AP console shows a

seconds counter, counting the number of seconds the mode button is pressed. Then:

• To reset the AP to it's default factory-shipped configuration, keep the mode button pressed for less

than 20 seconds. The AP's configuration files are cleared.

LED State

Red

Cycling through Red,

Green, Amber and off.

10M

Link

Active

Off

Blinking On

Possible Messages and Meanings

Software failure.

Try disconnecting and reconnecting power to the

AP.

General warning. Insufficient inline power.

100M

Link

Active

Off

Blinking On

1000M

Link

Active

Blinking