Cisco Aironet 1830 Series 시작하기 매뉴얼 - 페이지 10

{카테고리_이름} Cisco Aironet 1830 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1830 Series 44 페이지.
Cisco Aironet 1830 Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (45 페이지)

페이지 인쇄

Preparing the AP for Installation

Before you mount and deploy your access point, we recommend that you perform a site survey (or use

the site planning tool) to determine the best location to install your access point.

You should have the following information about your wireless network available:

• Access point locations.

• Access point mounting options: below a suspended ceiling, on a flat horizontal surface, or on a

desktop.

You can mount the access point above a suspended ceiling but you must purchase

Note

additional mounting hardware: See

on page 15

• Access point power options: power supplied by the recommended external power supply (Cisco

AIR-PWR-C), a DC power supply, PoE from a network device, or a PoE power injector/hub

(usually located in a wiring closet).

Access points mounted in a building's environmental airspace must be powered using PoE

Note

to comply with safety regulations.

Cisco recommends that you make a site map showing access point locations so that you can record the

device MAC addresses from each location and return them to the person who is planning or managing

your wireless network.

Installation Overview

Installing the access point involves these operations:

Step 1

Performing a Pre-Installation Configuration, page 11

Mounting and Grounding the Access Point, page 15

Step 2

Step 3

Powering the Access Point, page 16

Configuring and Deploying the Access Point, page 18

Step 4

for additional information.

"Mounting and Grounding the Access Point" section

(optional)