DigitaLinx IPEX2100 Series 빠른 설치 매뉴얼 - 페이지 12
{카테고리_이름} DigitaLinx IPEX2100 Series에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigitaLinx IPEX2100 Series 17 페이지.
페이지 인쇄IPEX2100 Series Quick Install Guide
Basic Installation
1.
Configure the gigabit switch for IP video operation. Liberty has guides for many common switch manufacturers
on the IPEXCB page on the Liberty website (www.libav.com).
2.
Turn off power and disconnect the audio/video equipment by following the manufacturer's instructions.
3.
Turn off power to the configured switch.
4.
Connect Category 5E or greater twisted pair cable with the TIA/EIA-568B crimp pattern between the LAN
port on the encoder(s) (IPEX2101) and the gigabit switch.
5.
Connect Category 5E or greater twisted pair cable with the TIA/EIA-568B crimp pattern between the LAN
port on the decoder(s) (IPEX2102, IPEX2102MV) and the gigabit switch.
6.
If the gigabit switch cannot provide power or enough power to the IPEX2100 devices, connect the included
power supply to the 12V DC power input of the device. If the gigabit switch cannot provide enough power,
disable the PoE function of the connected LAN ports on the switch.
7.
Connect an HDMI cable between the display and the decoder (IPEX2102, IPEX2102MV).
8.
Connect an HDMI cable between the source and the encoder (IPEX2101).
9.
Power on attached audio/video devices.
10.
Apply power to the gigabit switch.
11.
If the gigabit switch cannot provide power to the IPEX2101, IPEX2102 or IPEX2102MV, connect the included
power supply connected to the encoders and decoders to an AC outlet.
RS232 Connections
To use the RS232 control transport capabilities of the IPEXCB or the RS232 extension capabilities of the IPEX2101
or IPEX2102 / IPEX2102MV, connect the TX, RX, and ground control signal wires to the removable 3-pole terminal
block. Consult the manual of the source or display device(s) to determine which pins the TX and RX signals are
carried on. Be sure to always connect TX to RX and RX to TX.
Audio Output Connections
To use the analog audio outputs of the IPEX2101 or IPEX2102 / IPEX2102MV, connect the L, R, and ground wires to
the removable 3-pole terminal block. Connect the other end of the cable to an audio amplifier.
12
Installation Instructions
IPEX2000
Device
TX
RX
G
IPEX2100
Device
L
G
R
Source or
Display
RXD
TXD
GND
Ampli er
L+
L-
R-
R+