Argent Data Systems ADS-SR1 사용자 설명서 - 페이지 7

{카테고리_이름} Argent Data Systems ADS-SR1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Argent Data Systems ADS-SR1 20 페이지. Simplex repeater

If you are unable to get the receive audio level high enough, the solder jumper

marked SJ1, located on the circuit board near the DIP switch, may be cut to

increase gain. This jumper is present only on hardware revision 1.3 and above.

Setting the transmit audio level is a two-step process. First, the range can be set

roughly using DIP switches 1 and 2. The audio level will be lowest with both

switches off, and highest with both switches on.

When set properly, the transmitted audio should sound natural and not distorted

or 'clipped', without being excessively quiet. The ##98 command will cause the

unit to transmit a 1 kHz tone at full amplitude for several seconds, to help with

adjustment. If you can't find a combination of DIP switch settings that yields a

comfortable audio level, it can be further adjusted using a DTMF command,

detailed below.