Epson WN7512BEP 매뉴얼
{카테고리_이름} Epson WN7512BEP에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson WN7512BEP 2 페이지. Wireless lan unit
Epson WN7512BEP에 대해서도 마찬가지입니다: 사용자 설명서 (18 페이지)
페이지 인쇄
Wireless LAN Unit WN7512BEP
This guide presents important information intended to ensure safe and effective use of this product. Read this guide carefully
and store it in an accessible location.
FCC / Industry Canada (IC) Notices
This device complies with part 15 of FCC Rules and Industry Canada's licence-exempt RSSs. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Le présent appareil est conforme à la partie 15 des règles de la FCC et aux normes des CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas
produire de brouillage, et (2) l'appareil doit accepter tout brouillage subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the
FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment
should be installed and operated keeping the radiator at least 20 cm or more away from person's body. (*)
Cet équipement est conforme aux limites d'exposition aux rayonnements énoncées pour un environnement non contrôlé et respecte
les règles les radioélectriques (RF) de la FCC lignes directrices d'exposition et d'exposition aux fréquences radioélectriques (RF)
CNR-102 de l'IC. Cet équipement doit être installé et utilisé en gardant une distance de 20 cm ou plus entre le radiateur et le corps
humain. (*)
FCC Notices
Warning
You are cautioned that changes or modifications not expressly approved by Seiko Epson Corporation could void your
authority to operate the equipment.
Caution
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Epson America, Inc.
MS:3-13
3840 Kilroy Airport Way Long Beach, CA 90806
Tel: 562-290-5254
Industry Canada (IC) Notices
This Class B digital apparatus complies with Canadian ICES-003 and RSS-210. Cet appareil numérique de la classe B est
conforme à la norme NMB-003 et CNR-210 du Canada.
Specifications
Power-supply Voltage:
Current Consumption:
Frequency Range:
Potential Interference Range: 40 m
Appearance:
DC 4.5 - 5.5 V
Maximum 300 mA
2.4 GHz band
Wireless LAN unit: Approx. 24 x 51 x 10 mm (W x D x W)