Cisco Aironet 600 Series 사용자 설명서 - 페이지 12

{카테고리_이름} Cisco Aironet 600 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 600 Series 44 페이지. Officeextend access point
Cisco Aironet 600 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (4 페이지)

페이지 인쇄

Installing the Access Point

To install the Cisco Aironet 600 Series OfficeExtend Access Point, follow these steps:

Step 1

Plug one end of the Ethernet cable into the Ethernet port of your home router/gateway.

Step 2

Insert the other end of the Ethernet cable into the WAN port of the 600 Series OfficeExtend Access Point.

Note

Insert the power cord into the power connector of the 600 Series OfficeExtend Access Point.

Step 3

Plug the other end of the power cord into your power source.

Step 4

Press the power toggle switch on the access point to the ON position.

Step 5

DSL/Cable

Modem

Use the 600 Series OfficeExtend Access Point LED table

Step 6

LEDs located on the top panel of the access point.

The process of connecting the 600 Series OfficeExtend Access Point should only take 1 to 2 minutes.

Note

Your unit may require a software image download. If so, once the connection is made, the Status LED

on the top of the unit will flash blue. The Status LED continues flashing until download is complete.

When the download is complete, your access point will restart. Once connected to the controller, the

Status LED will display a solid blue or purple.

If your IT administrator has not pre-provisioned the 600 Series Office Extend AP with the IP address of

Step 7

the Primary Wireless LAN Controller, please follow the steps in the procedure

LAN Controller IP Address on the Access Point" section on page

You do not need to configure any SSIDs for your 600 Series OfficeExtend Access Point to connect to

Note

your company network. The access point receives the company SSID when it connects to the company

network by way of the Internet. If you have problems connecting to your company network, contact your

IT administrator. You can configure your local SSID Wireless LAN for other devices. See

Radio Channels on the Access Point" section on page 3-2

Cisco Aironet 600 Series OfficeExtend Access Point User Guide

1-4

The 600 Series OfficeExtend Access Point has different power requirements than other Cisco

enterprise access points, and this unit will be damaged if incorrect power is applied. Please refer

to the 600 Series OfficeExtend Access Point specifications for power supply requirements.

Router

Chapter 1

Unpacking and Installing the Access Point

Cisco Aironet

600 Series

OfficeExtend AP

(Table 1-1 on page

1-5) to understand the

"Configuring the Wireless

3-1, to configure this address.

for more information.

Client

"Configuring

OL-29882-03