Cisco Aironet AIR-CAP3602I-x-K9 시작하기 매뉴얼 - 페이지 38

{카테고리_이름} Cisco Aironet AIR-CAP3602I-x-K9에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet AIR-CAP3602I-x-K9 41 페이지. Aironet 3600 series lightweight access points

페이지 인쇄

Cisco Aironet AIR-CAP3602I-x-K9 시작하기 매뉴얼

<Default router> is the IP address of the default router, such as 10.0.0.1

<DNS Server> is the IP address of the DNS server, such as 10.0.10.2

Add the option 60 line using the following syntax:

Step 3

option 60 ascii "VCI string"

For the VCI string, "Cisco AP c3602". The quotation marks must be included.

Step 4

Add the option 43 line using the following syntax:

option 43 hex <hex string>

The hex string is assembled by concatenating the TLV values shown below:

Type + Length + Value

Type is always f1(hex). Length is the number of controller management IP addresses times 4

in hex. Value is the IP address of the controller listed sequentially in hex.

For example, suppose that there are two controllers with management interface IP addresses,

10.126.126.2 and 10.127.127.2. The type is f1(hex). The length is 2 * 4 = 8 = 08 (hex). The IP

addresses translate to 0a7e7e02 and 0a7f7f02. Assembling the string then yields

f1080a7e7e020a7f7f02. The resulting Cisco IOS command added to the DHCP scope is option 43 hex

f1080a7e7e020a7f7f02.

Access Point Specifications

Table 2 lists the technical specifications for 3602 series access points.

Table 2

Access Point Specifications