ACU-RITE 01607BPDI 사용 설명서 - 페이지 10
{카테고리_이름} ACU-RITE 01607BPDI에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ACU-RITE 01607BPDI 20 페이지. Weather center
페이지 인쇄
LOCATE AWAY FROM WIND OBSTRUCTIONS
DO NOT mount the sensor with obstructions around it.
Consider a location that is a wide open area, with few
structures around to ensure accurate wind speed measurement.
Visit us online to view installation photos and
video, or learn more about AcuRite technology:
www.AcuRite.com/3in1
3-in-1 Sensor Installation Guidelines
INSTALLATION HEIGHT
off the ground, in an open area. Higher is better for wind measurements - the
National Weather Service recommends 33 feet high!
MOUNTING OPTIONS
onto wooden posts or surfaces that are 2"x4" or larger. The sensor can also be
mounted directly to 3/4" steel pipe (available at hardware stores and home centers).
LEVEL INSTALLATION
bubble level (not included) to ensure
level installation for accurate wind
measurement.
Top or Side Mount
1. Insert the mounting base into the hole
on the bottom of the sensor.
2. Use one of the screws included in the
hardware bag to fasten the lower
sensor housing to the mounting base.
3. Fasten mounting base to a post or
railing using 2 screws.
Pipe Mount
1. Insert pipe or similar item all the way into
the hole on the bottom of the sensor. Note:
Mounting base is not used.
2. Use one of the screws included in the
hardware bag to fasten the lower sensor
housing securely to the pipe.
The 3-in-1 sensor is now ready to use.
Basic Setup is Complete
The 3-in-1 sensor will now synchronize with
the display unit. It may take a few minutes
for synchronization to complete. If both or one of the units appear to be functioning
improperly, please refer to the troubleshooting section.
Mount the sensor at a minimum height of 5 feet (1.5 meters)
The included mounting bracket is designed to screw directly
Use a
Top Mount
10
View Video
Side Mount
Pipe Mount
Do not install during
electrical storms.
Do not place pipe
or sensor near
electrical lines or
electrical equipment.