Cisco Catalyst IW-6300H-AC K9 Series 시작하기 - 페이지 2
{카테고리_이름} Cisco Catalyst IW-6300H-AC K9 Series에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst IW-6300H-AC K9 Series 20 페이지. Product document of compliance
페이지 인쇄Getting Started and Product Document of Compliance for the Cisco Catalyst IW6300 Heavy Duty Series Access Points
Introduction
Introduction
The purpose of this document is to provide the installer the necessary information for installing the Cisco Catalyst IW6300
Heavy Duty Series Access Points. The documentation is on-line, and subject to change. Make sure that you are
downloading or viewing on-line the latest version before beginning an installation.
This document also contains Product Compliance and Safety information as well as Declaration of Conformity. This
document also covers hazardous location specific considerations and instructions.
Items Shipped with your Device
Unpack the box and verify that all items listed on the invoice were shipped with the Cisco Catalyst IW6300 Heavy Duty
Series Access Points.
The typical access point package contains the following items:
Access point
—
IW-6300H-AC-x-K9 (AC power model)
—
IW-6300H-DC-x–K9 (DC power model)
—
IW-6300H-DCW-x-K9 (DC wide range power model)
Mounting kit (IOT-ACCPMK)
Ground lug and screws with lock washers
Weatherization tape and anti-seize compound
This document (Part Number 78-101483-01)
Optional Tools and Hardware
The optional tools and hardware that can be obtained from Cisco are:
Optional power injector (AIR-PWRINJ-60RGDx=)
Antennas, 2.4/5-GHz (refer to the data sheet for supported antennas)
Caution:
When installed into a hazardous location, the antenna must be passive and ATEX/IECEx certified to meet
IP66/67 ratings.
Optional banding strap tool (BAND IT) (AIR-BAND-INST-TL=)
Equipment that you supply
1/2" or 13-mm socket wrench, used to open the Access Cover and to attach the mounting bracket
#2 Phillips or Flat screw driver to clamp wire terminal and ground terminal
3/8" Allen wrench with 13-18" long wrench handle to remove 1/2" NPT port plugs
ATEX/IECEx certified Armored cable for routing in conduit
Customer supplied ATEX/IECEx certified 1/2" NPT conduit (rigid or flex), or ATEX/IECEx certified cable gland or
barrier gland for each connection suitable to maintain IP66/67
2