Cisco Catalyst IW6300 Series 시작하기 - 페이지 7
{카테고리_이름} Cisco Catalyst IW6300 Series에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst IW6300 Series 20 페이지. Product document of compliance
Cisco Catalyst IW6300 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (28 페이지)
Getting Started and Product Document of Compliance for the Cisco Catalyst IW6300 Heavy Duty Series Access Points
Grounding the Device
1.
If using insulated 6-AWG (13.3 mm
2.
Use the appropriate crimping tool to crimp the
bare 6-AWG (13.3 mm
the supplied grounding lug.
Note:
The grounding lug and hardware used
must comply with local and national electrical
codes.
3.
Open the anti-corrosion sealant (supplied), and
apply a liberal amount over the metal surface,
called the Ground Pad, where the ground strap
screw holes are located.
4.
Connect the grounding lug to the access point
grounding screw holes using the supplied two
Phillips head screws (M4 x10 mm) with lock
washers. Tighten the grounding screw to 22 to
24 lb-in (2.49 to 2.71 Nm).
5.
If necessary, strip the other end of the ground wire and connect it to a reliable earth ground, such as a grounding
rod or an appropriate grounding point on a metal streetlight pole that is grounded.
2
) copper ground wire, strip the insulation as required for the grounding lug.
2
) copper ground wire to
1—Ground pad
7
1