Cisco Catalyst IW6300H-AC 설치 매뉴얼 - 페이지 14

{카테고리_이름} Cisco Catalyst IW6300H-AC에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst IW6300H-AC 28 페이지.

Closing the Access Cover

To open the access cover, follow these steps:

Procedure

Step 1

Use 0.5-in (13-mm) box-end wrench or socket set to unscrew the two bolts on the front cover of the unit. Only

unscrew the bolts about 2 turns until they are easily turned by hand, and the bolts are resting on springs.

Figure 13: Access Point Front View of Cover

Step 2

The cover is hinged on the bottom, and the bolts are designed to be captive. Carefully open the cover and fold

the cover back.

Closing the Access Cover

To close the access cover, follow these steps:

Procedure

Step 1

Ensure that O-ring sealing surface is free of debris and that O-ring is undamaged and fully contained in groove.

Step 2

When closing the access cover, be careful not to pinch internal wires.

Step 3

Carefully position the cover flush with all sides of the access point, then slowly hand-tighten each bolt.

Step 4

When all bolts are hand-tightened, use a 13-mm closed-end wrench or socket to partially tighten the bolts in

the tightening sequence. Tighten each bolt to 3 to 4 ft lbs (0.34 to 0.45 Nm).

Step 5

Repeat Step 3 using the same tightening sequence to fully tighten each bolt to 6 to 7 ft lbs (0.68 to 0.79 Nm).

Installing the Access Point

M8 bolts

Installing the Access Point