Cisco Catalyst IW6300H-DC 설치 매뉴얼 - 페이지 10

{카테고리_이름} Cisco Catalyst IW6300H-DC에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst IW6300H-DC 28 페이지.

Pole Mounting

Step 3

For pole diameters of 3.5 inch (8.9 cm) or less, mount the pole clamp bracket assembly to a pole using two

metal straps looped through the space between the pole clamp bracket and the strap brackets to provide

maximum holding strength for extreme environments. Following the instructions provided with the banding

strap tool (BAND IT) (AIR-BAND-INST-TL=), loop each metal strap twice.

Caution

Step 4

Position the pole clamp bracket on the pole as needed before tightening the metal bands.

Note

Step 5

Tighten the metal bands using the banding strap tool (BAND IT) (Cisco AIR-BAND-INST-TL=) by following

the operating instructions in the box with the tool. Ensure that the metal bands are as tight as possible.

Step 6

Place the mounting bracket onto the pole clamp bracket support bolt.

Step 7

Install four M8 x16 bolts (with flat and lock washers) into the bolt holes.

Step 8

Hand-tighten the bolts and the nut (do not overtighten).

Step 9

Adjust the top edge of the mounting bracket until it is horizontal and tighten the bolts and the flange nut to

13 to 15 ft lbs (17.6 to 20.3 Nm).

Figure 9: Attach the Mount Bracket

Step 10

Screw a M8 x16 bolt (without a flat or lock washer) in the top support bolt hole on each side the access point.

Do not screw the bolt all the way in. Leave a gap of approximately 0.25 inch (0.635 cm).

Step 11

Position the two bolts on the access point onto the hands-free attach point of the mounting bracket.

Installing the Access Point

Pole clamp bracket

Strap slot in strap bracket

Do not place the metal straps in the large open area between the pole clamp bracket and the strap

brackets because this does not properly secure the access point.

When the metal bands are tightened to the full tension, the pole clamp bracket cannot be adjusted

unless the metal bands are cut or disassembled.

M8 x 16 bolts

Metal mounting strap

Pole

Flange nut

Installing the Access Point