Caberg Just SpeakS 사용자 설명서 - 페이지 7

{카테고리_이름} Caberg Just SpeakS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Caberg Just SpeakS 14 페이지. Bluetooth headset & intercom for scooters and motorcycles

페이지 인쇄

JUST SPEAK S

1st Mobile Phone

2nd Mobile Phone

Mobile Phone

Multipoint

Pairing

HFP

A2DP

JUST SPEAK S

Multipoint Mobile Phones Pairing

Bluetooth Stereo Device Pairing

1. If the Bluetooth stereo device is integrated with the mobile phone

such as smartphones, you don't need to pair the Just Speak S with it

separately. When the Just Speak S is paired with the mobile phone, it is

also paired as a stereo music device.

2. If you have a stand alone Bluetooth stereo device, follow the pairing

procedure separately. The procedure is the same as the procedure of

"Mobile Phone Pairing".

Note:

1. If Bluetooth connection between the headset and a mobile phone is

disconnected, press and hold the (+) Button for 3 seconds to recover the

Bluetooth connection immediately.

2. If Bluetooth connection between the headset and a media player is disconnected,

press and hold the (+) Button for 1 second to recover the Bluetooth connection

and play.

Bluetooth GPS Navigation Pairing

You can listen to voice instruction from Bluetooth GPS navigation. Some

GPS systems use mobile phone profile (HFP, Hands-Free Profile) and others

use stereo music profile (A2DP, Advanced Audio Distribution Profile). Most

motorcycle specific GPS systems use mobile phone profile for turn-by-turn

voice instruction. You can simultaneously use a mobile phone and a GPS

which uses mobile phone profile by one of the following procedures.

Multipoint GPS Pairing

If you use GPS only for turn-by-turn voice instructions, not for Bluetooth

stereo music streaming, multipoint pairing is recommended for the GPS

connection. Multipoint Bluetooth pairing allows the Just Speak S to connect

two HFP devices at the same time: mobile phone and GPS navigation.

Follow the steps below to pair the GPS using the multipoint pairing.

1. Turn on the headset and press and hold the (-) Button for 5 seconds until

the red LED is rapidly flashing and you hear multiple beeps.

2. Within 2 seconds, press and hold the (+) Button for 1 second, then

the LED turns to blue flashing and the beeps turn to high tone double

beeps. You will hear a voice prompt saying "Multipoint pairing".

3. Search for Bluetooth devices on the GPS navigation screen. Select the

Caberg Just Speak S in the list of the devices detected on the GPS.

4. Enter 0000 for the PIN.

5. The GPS confirms that pairing has completed and the Just Speak S is

ready to use. You will hear a voice prompt from the Just Speak S saying

"Your headset is paired".

6. If the pairing process is not completed within three minutes, the Just

Speak S will return to stand-by mode.

JUST SPEAK S

The pairing diagram for multipoint GPS pairing is shown in the figure below.

Mobile Phone

GPS Navigation

Mobile Phone

Multipoint

Pairing

HFP

A2DP

JUST SPEAK S

Multipoint GPS Pairing