Epson C11CA18201 - WorkForce 600 Color Inkjet 네트워크 설치 매뉴얼 - 페이지 3
{카테고리_이름} Epson C11CA18201 - WorkForce 600 Color Inkjet에 대한 네트워크 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson C11CA18201 - WorkForce 600 Color Inkjet 41 페이지. Using the control panel for wireless network installation
Epson C11CA18201 - WorkForce 600 Color Inkjet에 대해서도 마찬가지입니다: 중요한 설정 정보 (2 페이지), 사양 (2 페이지), 제품 지원 게시판 (5 페이지), 기능 설명서 (28 페이지)
페이지 인쇄
Wireless Network Installation
To add the printer to your wireless network, you need to know the name (SSID)
of your wireless network. If it has security enabled, you also need to know the
WEP key or passphrase. Write down the SSID and WEP key or passphrase below:
■
Network name (SSID): _________________________________________
■
WEP key or passphrase: _________________________________________
Note:
If the WEP key is either 5 or 13 characters, it's ASCII. If the WEP key is either 10 or 26
characters, it's hexadecimal. The default WEP key is usually 1.
If your passphrase contains upper- or lowercase letters, be sure to note it correctly.
The printer supports the following wireless security modes: WEP 64, WEP 128, and
WPA-PSK.
If you don't know your wireless network name (SSID) or WEP key or passphrase,
contact the person who set up your wireless network before you begin.
Connect the Ethernet Cable
Note:
This is a temporary connection used to configure the printer. You will be prompted to
remove the cable when configuration is complete.
1. Connect an Ethernet network cable to the
(
port on your printer.
LAN
10/100)
Wireless Network Installation
3