Cisco Meraki CW9162I-MR 하드웨어 설치 매뉴얼 - 페이지 18

{카테고리_이름} Cisco Meraki CW9162I-MR에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Meraki CW9162I-MR 23 페이지.

4.4 Verify Device Functionality and Test Network Coverage

1. Check LEDs

The LED should be solid white. If it is flashing orange, the firmware is automatically upgrading

and the LED should turn green when the upgrade is completed (normally in under thirty

minutes).

Note: Your CW9162I-MR must have an active route to the Internet to check and upgrade its firmware.

2. Verify access point connectivity

Use any 802.11 client device to connect to the CW9162I-MR and verify proper connectivity using the

client's web browser.

3. Check network coverage

Confirm that you have good signal strength throughout your coverage area. You can use the signal

strength meter on a laptop, smart phone, or other wireless device.

Reference the Meraki knowledge base at

information and troubleshooting tips.

Regulatory

FCC Compliance Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)

This de- vice may not cause harmful interference, and (2) this device must accept any interference

received, including interference

FCC Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residen tial installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to correct the interference by one

of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution

Any changes or modifications no expressly approved by Meraki could void the user's authority to operate this

equipment. This Transmitter must not be co-located or operation in conjunction with any other antenna or

transmitter.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with minimum distance 41 cm between the radiator and your

body. This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

http://meraki.com/support/knowledge_base

hat may cause undesired operation.

for additional