Cisco Meraki MR42 설치 매뉴얼 - 페이지 15

{카테고리_이름} Cisco Meraki MR42에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Meraki MR42 17 페이지.
Cisco Meraki MR42에 대해서도 마찬가지입니다: 설치 매뉴얼 (2 페이지)

Security Screw

Install the security screw in the lower mount cradle tab.

Kensington Lock

Attach a Kensington lock cable to the access point at the hard point on the side of the device.

Attach the other end of the cable to a secure location, such as a pipe or building ﬁxture.

Verify Device Functionality and Test Network Coverage

1. Check LEDs

a. The Power LED should be solid green (or blue, if clients are connected). If it is ﬂashing blue, the ﬁrmware is

automatically upgrading and the LED should turn green when the upgrade is completed (normally within a

few minutes). See the

b. Note: Your MR42 must have an active route to the Internet to check and upgrade its ﬁrmware.

2. Verify access point connectivity

a. Use any 802.11 client device to connect to the MR42 and verify proper connectivity using the client's web

browser.

3. Check network coverage

4. Conﬁrm that you have good signal strength throughout your coverage area. You can use the signal strength meter

on a laptop, smart phone, or other wireless device.

The following steps can be used for troubleshooting basic connectivity issues with your access point.

• Reset the access point

• Factory reset the access point by holding the factory reset button for 5 seconds

• Try switching cables, or testing your cable on another device

If your access point still does not connect, the following instructions may be useful, depending on your issue.

Check Radio Functionality by Making the AP a Repeater

1. If your AP is acting as a gateway, disconnect the Ethernet cable from the LAN (while keeping the AP powered

on). This will switch your AP into repeater mode. If no other gateways are within range, the AP will begin

broadcasting an SSID appended with "-scanning". If you are able to connect to this SSID and go to my.meraki.com

from your web browser, then your radio is working.

2. Physically place the repeater AP (AP with disconnected LAN) next to a working gateway AP.

3. Connect the power adapter or PoE. The radio and signal strength LEDs on the AP will turn solid green or blue

once the access point boots up and detects the gateway.

4. The access point is now a repeater and will check into Dashboard.

5. On dashboard under monitor and access points you will see the connectivity bar for the specific Repeater AP

"LED

Indicators" section for more details. .