Cisco Meraki MR45 설치 매뉴얼 - 페이지 12

{카테고리_이름} Cisco Meraki MR45에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Meraki MR45 16 페이지.
Cisco Meraki MR45에 대해서도 마찬가지입니다: 설치 매뉴얼 (15 페이지)

the MR45" section.

Electrical Junction Box Mount Using Mount Cradle

The MR45 can be mounted to a 4" square cable junction box, a 3.5 or 4" round cable junction box, or various U.S.

and European outlet boxes (mounting screws are not included).

Using appropriate mounting hardware for your specific type of junction box, attach the mount cradle to the

junction box

Power the MR45

If mounting to an electrical junction box, feed the Ethernet cable through the cable access hole in the mount cradle. If

mounting to a wall or ceiling, the Ethernet cable will feed from behind the MR45. The "Power Source Options" section of

this document lists the different powering options and their unique characteristics.

Mount the MR45

Attach the MR45 to the Mount Cradle

(This section applies to wall and/or solid ceiling, drop ceiling or electrical junction box mount

where you have already installed the mount cradle.)

The MR45 attaches to the mount cradle with two tabs on the cradle that insert into the MR45, and is secured to the

cradle using one screw.

To attach the MR45 to the mount cradle properly, line up the top edge of the AP with the top tab of the mount cradle.

Since the cradle is already mounted to the wall, guide the MR45 towards the top tab and insert the top tab into the

MR45s slot.