Epson C11CA96201 빠른 설정 지침 - 페이지 2
{카테고리_이름} Epson C11CA96201에 대한 빠른 설정 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson C11CA96201 4 페이지. C11ca96201 all-in-one printer
페이지 인쇄2
Open the cartridge cover.
3
Shake the ink cartridges gently 4 or 5 times, then unpack
them.
4
Remove only the yellow tape from each cartridge.
Caution:
Don't remove any other seals or the cartridges may
leak.
5
Insert the cartridges in the holder for each color.
6
Press each cartridge down until it
clicks.
7
Close the cartridge cover. Press
down until it clicks.
8
Lower the scanner unit.
9
Press OK to prime the ink delivery system. This takes
about 5 minutes.
Note:
Your printer ships with full cartridges and part of the ink
from the first cartridges is used for priming the printer.
Caution:
Don't turn off the printer while it is priming or you'll
waste ink.
10
When you see this menu on
your product's LCD screen,
do not press any buttons
yet. Continue following the
instructions in the following
sections to load paper in your
product and install software.
5
Load paper
You can load 3.5
5 inch (89
453 mm) paper. For instructions on loading envelopes,
legal-size paper or larger paper, see the online User's Guide.
1
Pull out one of the paper
cassettes at the bottom of
the printer.
2
Slide the edge guides outward, and position the guide
shown below for the size of paper you're using.
Note:
To load wide-format paper, press the tray release button
and pull the paper tray as shown until it clicks into place.
3
Insert the paper with the glossy or printable side
facedown.
4
Slide the edge guides against the paper, but not too
tight. Make sure the paper is under the tabs on the edge
guides.
5
Replace the cover and gently insert the paper cassette.
6
Extend the output tray as shown.
127 mm) to 13
19 inch (330