Argo ADIAS19DC 설치 지침 매뉴얼 - 페이지 13

{카테고리_이름} Argo ADIAS19DC에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo ADIAS19DC 19 페이지. Split air conditioner system
Argo ADIAS19DC에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지)

페이지 인쇄

17 - OUTDOOR/INDOOR UNIT REFRIGERANT CIRCUIT ADDRESS

Indoor units that are part of a multisplit system must be properly configured to be able to communicate with the

outdoor unit over different channels (Indoor A, Indoor B, etc...) of the communication bus.

Each indoor unit address must correspond to the physical connection of the indoor unit to the outdoor unit refrigerant

circuit, i.e.:

Refrigerant Circuit A <--> Indoor Unit Address A

Refrigerant Circuit B <--> Indoor Unit Address B

...

There are three methods to set the address of an indoor unit:

(1) Dip-switch setting: the address is set by mean of a dip-switch located on the indoor unit pcb.

(2) Remote controller procedure: the address is set by mean of a special setting on the remote controller.

(3) Automatic addressing procedure: the address is automatically set on every indoor unit of the system by mean of

an automatic procedure.

(1) ADDRESS SETTING THROUGH DIP-SWITCHES (UP TO 4 INDOOR UNITS)

Disconnect the power

Check that the setting of switch SW2 (PCB) corresponds to the figure:

INDOOR UNIT A

SW2

(PCB factory state)

1=off

2=off

INDOOR UNIT C

SW2

1=off

2=on

PCB

INDOOR UNIT B

SW2

PCB

1=on

2=off

INDOOR UNIT D

SW2

PCB

1=on

2=on