Cisco Meraki MR84 하드웨어 설치 매뉴얼 - 페이지 10

{카테고리_이름} Cisco Meraki MR84에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Meraki MR84 13 페이지.

Unscrew it with a coin or flathead screwdriver.

2. Route the Ethernet cable from the PoE Injector "OUT" port to the

MR84.

3. Install a cable gland on the MR84 end of the cable.

4. Plug the Ethernet cable into the Ethernet port of the Meraki MR84.

a. Connect the cable to the Ethernet port on the MR84.

b. Screw the gland body into the threaded hole of the port. Use

an adjustable wrench to make sure the gland body is fully

seated in the hole.

c. Insert the split ring gasket into the gland body.

d. Screw the cap tightly onto the gland. You may need a

wrench to fully tighten the cap, but take care not to damage

the cable in the process.

Optional: Make the MR84 a gateway

1. Connect an active internet connection to the "IN" port of the PoE injector.

4.2.3.6 Attach Grounding Strap

Connect one end of grounding strap to grounding post with included screw

and washer. Securely attach the other end nearby metal structure.

4.4 Verify Device Functionality and Test Network

Coverage

1. Check LEDs The Radio Power LED should be solid white. If it is cycling

rainbow, the firmware is automatically upgrading and the LED should

turn white when the upgrade is completed (normally in under thirty

minutes).

2. Note: Your MR84 must have an active route to the Internet to check and

upgrade its firmware.

3. Verify access point connectivity Use any 802.11 client device to connect

to the MR84 and verify proper connectivity using the client's web

browser.

4. Check network coverage Confirm that you have good signal strength

throughout your coverage area. You can use the signal strength

meter on a laptop, smart phone, or other wireless device.