Argo ADIBS13DC 사용 설명서 - 페이지 10

{카테고리_이름} Argo ADIBS13DC에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo ADIBS13DC 15 페이지. Split air conditioner system
Argo ADIBS13DC에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (19 페이지), 사용 설명서 (17 페이지)

페이지 인쇄

tIPS FoR EnERGY SAVInG

Do not:

Block the air intake and outlet of the unit.

If they are obstructed, the unit will not work well, and

may be damaged.

Let direct sunlight into the room. Use sunshades,

blind or curtain.

Do:

Always try to keep the air filter clean. A clogged filter

will impair the performance of the unit.

To prevent conditioned air from escaping, keep

windows, doors and any other openings closed.

tRoUBLEShootInG

The use of portable telephones near the air conditioner

may cause disturbance to its normal operation and must

be avoided. In case abnormal operation is noticed,

(OPERATION lamp lights, but the air conditioner will not

run) to restore normal operation turn-off electric supply

for about 3 minutes, by disconnecting the main switch

or the wall plug, then start again the air conditioner.

If your air conditioner does not work properly, first check

the following points before requesting service.

If it still does not work properly, contact your dealer or

service centre.

WARnInG

trouble: the air conditioner does not run at all.

Possible cause:

1. Power failure.

2. Leakage breaker tripped.

3. Operation button is OFF.

4. Batteries in remote control unit have run down.

Remedy:

1. Restore power.

2. Contact service centre.

3. Press the button again.

4. Replace batteries.

trouble: Poor cooling or heating performance.

Possible cause:

1. Dirty or clogged air filters.

2. Heat source or many people in room.

3. Doors and/or windows are open.

4. Obstacle near air intake or air discharge port.

5. The set temperature on the remote control unit is too

high.

6. Outdoor temperature is too low (heat pump version).

7. Defrosting system does not work (heat pump version).

Remedy:

1. Clean air filters to improve airflow.

2. Eliminate heat source if possible.

3. Shut them to keep the heat or cold out.

4. Remove it to ensure good airflow.

5. Set the right temperature on the remote control unit.

6. Try to use a back-up heater.

7. Consult your dealer.

trouble: Clicking sound is heard from the air conditioner.

Possible cause:

1. During operation, any plastic parts may expand or

shrink due to a sudden temperature change. In this

event, a clicking sound may occur.

Remedy:

1. This is normal, and the sound will disappear when an

even temperature is settled.