Cisco MR18 설치 매뉴얼 - 페이지 9

{카테고리_이름} Cisco MR18에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco MR18 16 페이지.
Cisco MR18에 대해서도 마찬가지입니다: 빠른 매뉴얼 (2 페이지)

Choose Your Mounting Location

A good mounting location is important to getting the best performance out of your MR18 access point. Keep the

following in mind:

1. The device should have unobstructed line of sight to most coverage areas. For example, if installing in an ofﬁce

ﬁlled with workspaces divided by mid-height cubicle walls, installing on the ceiling or high on a wall would be ideal.

2. Power over Ethernet supports a maximum cable length of 300 ft (100 m).

3. If being used in a mesh deployment, the MR18 should have line of sight to at least two other Meraki devices. For

more detailed instructions regarding access point location selection, reference the Meraki Network Design Guide

(meraki.cisco.com/library/).

Install the MR18

For most mounting scenarios, the MR18 mount cradle provides a quick, simple, and ﬂexible means of mounting your

device. The installation should be done in two steps. First, install the mount cradle to your selected location. Then,

attach the MR18 to the mount cradle.

Attach the mount cradle

The MR18 mount cradle can be used to install your access point in a wide range of scenarios: wall or solid ceiling, below

a drop ceiling, on various electrical junction boxes, or above a drop ceiling (in the plenum).

The mount cradle contains a variety of hole patterns that are customized for each installation scenario. The mounting

template (included inbox with mount cradle) should be used to drill holes for wall mounts and also to identify the correct

hole patterns in the mount cradle that should be used for each type of mount. The included mount cradle template

shows the hole patterns that should be used for each type of mount.

Wall or Solid Ceiling Mount Using mount cradle

Using included wall anchors and screws, attach the mount cradle to your mounting wall or ceiling. It is recommended

that the MR18 be mounted to a wall or solid ceiling using the mount cradle for physical security reasons.

Drop ceiling mount using mount cradle

To mount your MR18 on a drop ceiling T-rail, use the included drop ceiling mounting accessory kit. The accessory kit

can be used to mount to most 9/16", 15/16" or 1 ½" T-rails. The kit contains:

• Drop ceiling mounting clips with set screws