Cisco NCS 4201 설치 매뉴얼 - 페이지 27

{카테고리_이름} Cisco NCS 4201에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco NCS 4201 42 페이지.

Installing the Cisco NCS 4201

Caution

Do not remove the dust plugs from the fiber-optic SFP module port or the rubber caps from the fiber-optic

cable until you are ready to connect the cable. The plugs and caps protect the SFP module ports and cables

from contamination and ambient light. Store the dust plugs for later use.

Step 5

Insert the cable connector into the SFP module:

• For fiber-optic SFP modules, insert the LC cable into the SFP module.

• For copper 1000BASE-T SFP modules, insert the RJ-45 cable connector into the SFP module.

Removing SFP Modules

To remove an SFP module from a module receptacle, follow these steps:

Step 1

Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.

Step 2

Disconnect the cable from the SFP module, and insert a dust plug into the cable end.

For reattachment, note which cable connector plug is send (TX) and which is receive

Tip

(RX).

Step 3

SFP module with Bale-Clasp Latch—Pull the bale out and down to eject the module as shown in figure Removing a

SFP Module with Bale-Clasp Latch From Cisco NCS 4201. If the bale-clasp latch is obstructed and you cannot use your

index finger to open it, use a small, flat-blade screwdriver or other long, narrow instrument to open the bale-clasp latch.

Removing SFP Modules

Cisco NCS 4201 Hardware Installation Guide