Cisco Small Business WAP561 빠른 시작 매뉴얼 - 페이지 3
{카테고리_이름} Cisco Small Business WAP561에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Small Business WAP561 13 페이지. Reboot and reset to factory default settings
Cisco Small Business WAP561에 대해서도 마찬가지입니다: 데이터시트 (8 페이지), 검토 (6 페이지), 빠른 시작 Quide (13 페이지), 브로셔 및 사양 (4 페이지), 매뉴얼 (4 페이지)
페이지 인쇄
Cisco WAP551 and WAP561 Wireless-N
2
Access Points Features
Front Panel
The front panel of the devices consists of three lights: Power, WLAN, and
LAN. For full descriptions of the colors of the lights and their indications,
see
"Verifying the Hardware
A Kensington lock slot is found under the lights.
Back Panel
The back panel of the devices has an RJ-45 Ethernet port. Use the
Ethernet port to power your device using PoE. It is an auto-sensing,
Gigabit Ethernet (802.3) port used to connect your WAP devices to
network devices, such as computers, routers, or switches. Cisco strongly
recommends using Category 5e or better cable for Gigabit
connectivity.
Side Panel
The side panel of the devices has a Reset button. See
Devices or Returning them to their Factory Default Settings"
information on the Reset button.
Default Settings
Parameter
Username
Password
LAN IP Address
Fallback LAN IP
Subnetwork Mask
If you are using a Cisco RV Series router, the default range for the DHCP
assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
Cisco WAP551 and WAP561 Wireless-N Access Points
Installation".
Default Value
cisco
cisco
DHCP address assigned
by server
192.168.1.245
255.255.255.0
"Rebooting the
for
3