Cisco WAP125 빠른 시작 매뉴얼 - 페이지 3
{카테고리_이름} Cisco WAP125에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WAP125 13 페이지. Wireless-ac/n dual band desktop access point with poe
Cisco WAP125에 대해서도 마찬가지입니다: 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (14 페이지)
페이지 인쇄
Cisco WAP125 Features
2
Front Panel
The front panel of the Cisco WAP125 consists of one system LED. For full
description of the colors of the lights and their indications, see
the Hardware
Installation.
Back Panel
RESET—See
Rebooting the Cisco WAP125 or Resetting to Factory
Defaults
for information on the RESET button.
LAN (PoE)—The RJ-45 Ethernet port is used to power the Cisco WAP125
using PoE. It is an auto-sensing, Gigabit Ethernet (802.3) port used to
connect the Cisco WAP125 to network devices, such as computers,
routers, or switches. We strongly recommend that you use a Category
5e or better cable for Gigabit connectivity.
POWER—The POWER button is used to turn the power on and off. It is not
applicable when using PoE.
12V DC—The 12V DC jack is used to connect the supplied power adapter
to the Cisco WAP125 if you are not using PoE.
Kensington Lock Slot—The Kensington lock slot is used to attach a cable
and lock to the Cisco WAP125.
Default Settings
Parameter
Username
Password
LAN IP Address
Fallback LAN IP
Subnetwork Mask
If you are using a Cisco RV Series router, the default range for the DHCP
assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
Cisco WAP125 Quick Start Guide
Default Value
cisco
cisco
DHCP address assigned by server
192.168.1.245
255.255.255.0
Verifying
3