Cisco WAP321 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} Cisco WAP321에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WAP321 13 페이지. Reboot and reset to factory default settings
Cisco WAP321에 대해서도 마찬가지입니다: 검토 (6 페이지), 데이터시트 (8 페이지), 빠른 시작 매뉴얼 (13 페이지), 브로셔 및 사양 (4 페이지), 매뉴얼 (4 페이지), 매뉴얼 (4 페이지)

페이지 인쇄

Possible Cause of Failure

Devices Can't Connect using Wi-Fi

• Complete the Setup Wizard. The Wi-Fi radio on the device is turned off

by default, and the Setup Wizard activates it. For users who do not wish

to use the Setup Wizard, log into the device using a Cat5e Ethernet

cable, and activate the Wi-Fi radio manually. See the Administration

Guide for details on activating the Wi-Fi radio.

No Power

• Power up the switch and your computer if they are turned off.

• If your access point is using PoE, make sure your PoE switch is powered

on and the lights indicate that you have a link. See

Hardware Installation" on page

• Verify that the power button is on; only applicable if you are not using

PoE.

• Verify that the devices on your network are not plugged into a

switchable outlet.

Bad Ethernet Connection

• Check the state of the indicator lights. See

Installation" on page

• Check the Ethernet cable to ensure that it is firmly connected to your

devices. Devices connected by the Ethernet cable can include the WAP

device, any switches, and your computer.

• Verify the connected switch has auto-negotiation enabled. The access

point and the switch need the same negotiation parameters set.

Bad Image

After a new firmware installation, if the Power light is flashing quickly,

contact system support; see

Incorrect IP Address

The most likely cause of connectivity failure is an incorrect IP address. The

Web browser may be pointed to the wrong IP address, or your computer

may be configured with an IP address that is not in the same subnet as the

device.

Cisco WAP121 and WAP321 Wireless-N Access Points

"Where to Go From Here" on page

"Verifying the

"Verifying the Hardware

11.