Cisco WAP371 매뉴얼

{카테고리_이름} Cisco WAP371에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WAP371 5 페이지. Reboot and reset to factory default settings
Cisco WAP371에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (15 페이지), 빠른 시작 매뉴얼 (38 페이지), 매뉴얼 (4 페이지)

페이지 인쇄
Cisco WAP371 매뉴얼
Reboot and Reset Factory Default Settings on
the WAP371
Objective
The factory default reset erases all configuration settings that have been modified by the
user, and restores the device to its original settings. This may be helpful if you lose the
password to a device and wish to regain access.
Note: It is advised to save a backup copy of the configuration before beginning this process.
Refer to Download/Backup Configuration on the WAP 371 for additional information.
Performing a reboot restarts the device with a saved configuration.
The objective of this article is to show you how to reset to factory default settings and how to
reboot a WAP371 Wireless Access Point.
Applicable Devices
• WAP371
Software Version
• 1.0.1.5
Reset to Factory Default
There are two ways to reset the Access Point to the factory default configuration:
• Hardware reset
• Reset with the use of the web configuration utility
Hardware Reset
Step 1. Press the Reset button for approximately ten seconds with a pin located at the back
of the device.
The Access Point reloads and is set to the default configuration settings.