Cisco WAP500 Series 매뉴얼

{카테고리_이름} Cisco WAP500 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WAP500 Series 4 페이지. Reboot and reset to factory default settings
Cisco WAP500 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (6 페이지)

페이지 인쇄

Reboot and Reset the Wireless Access Point

to Factory Default Settings

Objective

Rebooting or restarting the Wireless Access Point (WAP) deletes the logs stored in the

volatile memory. This process is performed when certain changes in the settings need a

reboot or if the WAP is not responding or booting up properly. Resetting the WAP to factory

default settings, on the other hand, erases all configurations that have been set by the user,

and restores the device to its original settings. A reset is recommended if most of the WAP

settings need to be reconfigured.

This article aims to show you how to reboot and reset your WAP to factory default settings.

Applicable Devices

WAP100 Series

WAP300 Series

WAP500 Series

Software Version

1.0.6.5 - WAP121, WAP321

1.0.2.8 - WAP131, WAP351

1.0.1.7 - WAP150, WAP361

1.3.0.3 - WAP371

1.2.1.3 - WAP551, WAP561

1.0.0.17 - WAP571, WAP571E

Reboot the Wireless Access Point

There are two ways to reboot the WAP:

Hardware reboot

Reboot through the web-based utility

Note: Images may vary depending on the exact model of your WAP. The images below are

taken from the WAP321.

Hardware Reboot

You have two ways to reboot the device hardware:

Turn the device off by pressing the POWER button while the device is connected to the

power outlet.

Note: The POWER button only works if the device is using a power adapter. If power is

supplied through Power over Ethernet (PoE), unplug your Ethernet connection for three